TamiyaUSA.com - Teaching your MFC-UNIT

Tamiya MINI 4D EDUCATIONAL

Home>
Teaching your MFC-UNIT

Configuration (teaching) is required to check each individual transmitter's performance, regardless of the manufacturer. Make sure to perform configuration every time you change the transmitter or use a new transmitter. Below you will be guided through the transmitter teaching mode, please reference your instructions for trim & transmission teaching techniques.

Set trims to Neutral

Turn on transmitter

Turn on MFC-02

Step #1

Hold SW3 button for more than 1 and less than 3 seconds. Hazard lights will flash and engine sound will shut off. Power light and control unit will blink.

Step #2

Move Left stick from UP to DOWN position

Step #3

Move Left stick from RIGHT to LEFT position

Step #4

Move Right stick from UP to DOWN position

Step #5

Move Right stick from RIGHT to LEFT position

Step #6

Push SW3 button and engine sound will start up.

Troubleshooting

If the above did not work and controls are not set correctly follow the below instructions to reset the MFC-02 and try above steps again.

Reset to Defaults

Turn off the MFC-02
Turn on MFC-02 while holding down SW3 button
All settings with return to defaults